Tidying up

1. Make appropriately named directories on /home/cometraid2
2. Copy the interferogram files to this directory (see below for details of which files to use)

1. The location of the files should be as follows for ERS interferograms

This is the format:

/home/cometraid2/interferograms/ers/track_{#}/ers{11/22/12/21}_{date1}_{date2}/frame_{start #}_{end #}/

e.g. /home/cometraid2/interferograms/track_35/ers12_930628_950831/frame_2801_2855/

If it does not exist, you should also make a directory like this :

/home/cometraid2/interferograms/{coseis / interseis / postseis / dem}/{country}/{area}/ers/track_{#}{a/d}/

e.g  /home/cometraid2/interferograms/application/interseis/turkey/east/ers/track_35d/

where a/d is short for ascending/descending.

Go to that directory and insert a link to your new interferogram files:

e.g. "ln -s /home/cometraid2/interferograms/ers/track_35/ers12_930628_950831 ."

2. Files to keep

It is probably easiest to make a directory called "keep", and move all of these files to it. Then copy them all to cometraid1.
Where an image file is listed (*int, *cor, *unw), also keep its corresponding .rsc file.

processing script
date1-date2.proc

log files from the int directory
int*/log  
int*/log1

slc resource flles
date1.slc.rsc, date2.slc.rsc

baseline file
date1_date2_baseline.rsc

full resolution interferogram
date1-date2.int

multilook interferograms (with topo correction, filtered&unfiltered, ODR&SIM, wrapped&unwrapped), correlation
date1-date2-sim_ODR_nrlks.int      [n=2,4,8,16 ??... number of looks]
filt_date1-date2-sim_ODR_nrlks.int
filt_date1-date2-sim_ODR_nrlks_c10.unw  [10 = correlation threshold... might be 15,20...]
date1-date2-sim_SIM_nrlks.int
filt_date1-date2-sim_SIM_nrlks_c10.unw
date1-date2_nrlks.cor

icu files - keep the icu input files if you have unwrapped with icu.
icu.in

geocoding/geocoded files (and files needed for redoing baseline correction)
radar_nrlks.hgt
radar_ODR_nrlks.unw
date1-date2_cull.off
date1-date2_nrlks_SIM.aff
rect_lookup.in  [this program does the geocoding]
../GEO/geomap_nrlks.trans  [you need this lookup table to do the geocoding again. Note the file in the int* directory is just a link. Do not copy this.]
geo_*   [keep all of the output geocoded interferograms, and any ermapper headers]

hdr orbit files
hdr_data_points*.rsc  [in case you need to use the header orbit information again]